Updates & Revisions - Woodsmith Magazine

Updates & Revisions

Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.

Woodsmith Issue 170 cover image

April 2007
Issue 170

Classic Modular Bookcase
Page 31: Cutting diagram
In the cutting diagram for the optional door and drawers at the bottom of the page, parts "H" and "I" are reversed.
Page 29: Illustration
Clarification: The callouts for parts K and L only show the length. Part K is 3/8" x 3/8" - 17 7/8" and part L is 3/8" x 3/8" x 2 7/8".
Page 49: Magnetic Catch part number
The part number for the magnetic catch is 01L05.20 (not 00S16.01 as originally printed).
Page 31: Cutting Diagram
Item J (Drawer Front Panels) should read (2) 1/4 ply. - 3 5/8" x 18 5/8" (not 11 5/8" as originally printed.)
Page 31: Materials & Supplies List
The lengths of parts H and I are reversed. (They are shown correctly in the cutting diagram).
Page 31: Cutting Diagram
Multiple corrections to cutting diagram: (1) The half sheet of plywood that is used for part E should be labeled as 1/4" - 48" x 48". (2) Only two part N pieces are shown on the diagram, but there should be four. The materials list is correct. (3) The diagram correctly shows three part Ps at 11 3/4", but also shows two more pieces labeled as P which are considerably longer. Those two pieces should be labeled as part Q. (4) Parts C and D should be cut from poplar rather than oak as illustrated (for cost savings only). (5) In the Optional Door and Drawer Materials, Supplies, & Cutting Diagram, parts K and L should both be 3/8" x 3/8".
Page 25: Illustration
Part N (shelf) and part O (shelf edging) should be 21 3/8", not 21 1/2" as printed. (The cutting diagram on p. 31 is correct.)
Page 24: Shelf Pin Hole Layout Illustration
The 2 1/4" dimension (the distance between the shelf edge and the shelf pin holes) should be changed to 1 3/4". The callout that says Front edge should say Back edge.
Page 27: Main illustration
On Part Z (Face Rail), the art should indicate a 1/2" cove profile, not a roundover profile as originally printed. (The text correctly refers to it as a cove profile.)
Five-Drawer Desk
Page 42: Illustration detail a.
The depth of the dado in the How-To: Dado box should be 3/16" to match detail 'b' at the top of the same page
Page 43: Cutting Diagram
Two Corrections: (1) The dimensions for part D (End case drawer runner) and part H (Center case drawer runner) should be 3/4" x 1/2", not 3/4" x 9/16" as printed. (The same measurement appears on page 36, detail a.) (2) The diagram for the 1/4" maple plywood should be 48" x 48", and there should be four each of part X.
Page 37: Illustration detail a
The dimension for the location of the drawer runner in detail 'a' on page 37 should be 1-5/16", not the 1-7/16" shown. The drawer runner location is identical for all of the drawers.
Page 36: Illustration detail a, front section view
The dimensions of part D (End case drawer runner) should be 3/4" x 1/2", not 3/4" x 9/16" as printed. (The same measurement is found in the cutting diagram on page 43.)
Routed Bowls
Page 21: Left Illustration
The left drawing for the "Large Round Bowl" neglects to include the width of the stave sections. That dimension is 2"