Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.
April 2008
Issue 176
- Charging Station
- Page 20: Materials, Supplies & Cutting Diagram
- Parts B, C and D should all be 11" in length, not 10 3/4" as originally printed. The correct measurement is shown in the drawings throughout the article.
- Page 20: Main Illustration
- The support panel (part G) is 4 5/8" high, as listed in the material cutting diagram.
- Page 20: Materials, Supplies & Cutting Diagram
- The second part E shown in the cutting diagram should be labeled part H and should be listed as (.3 bd. ft.) not square feet since it is 3/4"-thick material. Also, graphically, since both part E's are 4" x 12", the two boards should both look the same size in the diagram.
- Classic Oak Wine Server
- Page 35: References to the bevel angle
- The text and the illustration of the bevel give a blade tilt angle of 30 degrees; this is too steep. The angle should be about 18 degrees.
- Page 34: Detail A
- The measurement at the top of the detail for placement of the magnet should be 4 1/4" from the notched edge of the front stretcher. Note: The measurement is correct as shown in the drawing on page 32.
- Page 32: Detail B
- The spacing between the predrilled screwholes was not correctly illustrated: The first screw should be 7/8" from the edge. The next space should be 3 7/8" from the first screw. Then there should be three spaces of 4" each. Finally the 3 7/8" repeats and then another 7/8" at the end.
- Page 51: Hardware source
- The source for the pivot hinges was omitted. Lee Valley sells the Steel Pivot Hinge, part number 00H03.11.
- Page 32: Detail 'a'
- The hole for the "pivot hinge cup" is called out as 7/64". It should be 17/64"
- Page 37: Detail 'a'
- The arrow for the lowest part labeled 'Q' should be extended to point to the next item (Wine Rack Shelf) above the bottom shelf, not the bottom shelf as illustrated.