Updates & Revisions - Woodsmith Magazine

Updates & Revisions

Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.

Woodsmith Issue 227 cover image

October 2016
Issue 227

Box-Jointed Craft Center
Page 41: Supplies list
The Materials and Supplies list suggests you need (2) continuous hinges. At the length given, only one hinge is necessary to complete the project.
Domed-Top Steamer Trunk
Page 46: Main illustration
There is a discrepancy in the width of the Bottom Rail (H). The drawing on p.46 says it's 2 5/8" wide. The materials list shows 2 1/4". The materials list is correct.
Page 48: Figure 3a
Figure 3a advises the woodworker to 'maintain a 2 1/4" rail width.' It should read 2 3/8"
One-Wall Workshop: Versatile Carts
Page 29: Main illustration
In the main drawing, the cutout on the Drawer Front (I) is shown to be 6" wide and 8" from the end of the workpiece. However, that doesn't center the cutout on the front. The 8" dimension should be 9".
Page 29: Main illustration
The False Front (K) is listed as 27 1/2" in the main drawing, but 27 1/4" in the materials list. The materials list is correct.
Shop Notes
Page 65: Main illustration
In the drawing on the top of page 65, the template blank is listed as 8 3/8" x 23 1/2". It should be 8 1/2" x 23 1/2". In locating the opening, the centerline is 2" down from the top edge and 6 3/4" from the lower edge. It should be 6 1/2" from the lower edge.