Updates & Revisions
Here you will find important updates and revisions to the articles and plans published in Woodsmith magazine.
October 2017
Issue 233
- Auxiliary Vise
- Page 40: Note
- The note at the top of the page on peening metal parts refers to page 66. It should refer to page 65.
- Page 40: Side View Illustration
- No dimension is listed for the 2nd set of upper holes on the side view of the side plate. The dimension should be 3 3/8".
- Board Games
- Page 64: Main Illustration and Detail 'a'
- In the main illustration and detail 'a', several dimensions are incorrect. The length of the template sides and ends are too long by 1/4".
- Hall Bench
- Page 44: Figure 1, Detail 'a'
- Figure 1, detail 'a' at the bottom of page 44 should show 7/8" from the back edge instead of 1".
- Miterless Picture Frames
- Page 33: Items A & B
- In Material & Supplies, items A & B were printed as follows: A Stiles (2) 3/4 x 3 - 12 1/2; B Rails (2) 3/4 x 3 - 4 1/2. They should read: A Stiles (2) 3/4 x 3 – 9 1/2; B Rails (2) 3/4 x 3 – 7 1/2.
- Page 33: Main Illustration
- In the main drawing at the top of the page, the dimensions for the stile and inlay are incorrect. They should be 9 1/2. The dimension for part A in the materials list should also be 9 1/2.
- Shop Notes
- Page 64: Main Illustration
- The length of the jig ends and template sides is incorrect. The jig end should be 6 1/2", and the template side should be 12".
- Table Saw Storage Cart
- Page 29: Cutting Diagram
- Part "D" in the 1/2"x7"-84" board layout should be labeled "E" instead of "D".